Vader Style Mask
por 3D-Art-and-Designs en Cults3D
If you enjoyed this design, please click the Like button and follow me here on Cults3D.
Cults3D entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a 3D-Art-and-Designs.
Archivos (7)
- BottomGrill_Insert.obj OBJ
- FrontGrill_Insert.obj OBJ
- StrapLockX1.stl STL
- StrapLocksX4.stl STL
- Strap_Locks.obj OBJ
- VM_RSRMRT_V1.obj OBJ
- VM_RSRMRT_V1.stl STL
- Categoría
- Cosplay y props
- Formatos
- OBJ, STL
- Descargas
- 4,300
- Publicado
Sobre este modelo
If you enjoyed this design, please click the Like button and follow me here on Cults3D.
If you could also upload a picture of your make, it would help others to find this design.
If you find any issues with this design, please leave a comment at the bottom of this page.
This mask has been shaped to fit an adult size face.
If printing with PLA:
After printing, warm it with a heat-gun or hot water to shape it to the contours of your face. Take care not to burn your face.
Take your time to shape the mask and a good tight but comfortable seal can be achieved. Cover the vents with the palms of your hands to check for air flow.
Strap slots are made to fit 12mm * 2mm elastic straps.
The mask has no filters but you might use it to hold some form of filter material against your face, eg. a microfibre cloth or surgical mask. Or use duct tape to tape some filter inside the mask.
Disclamer: This design carries no form of guarantee! The designer cannot be held liable on any grounds, if anyone uses a physical copy of this mask for any purpose.
File List:
VM_RSRMRT_V1.stl
StrapLocksX4.stl
StrapLockX1.stl
VM_RSRMRT_V1.obj
StrapLocks.obj
FrontGrill_Insert.obj (incomplete)
BottomGrill_Insert.obj (incomplete)
Descripción original del autor, publicada en Cults3D.
