*Updated* Necklace and jewelry holder, various heights
por RocketEngineerByDay en Printables
*Updated* Jewelry holder. Necklaces on top. Bracelets, rings and earrings in the base.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a RocketEngineerByDay.
Archivos (9)
- Necklace Holder Top REBD.stl STL · 1,1 MB
- Necklace Holder Base REBD.stl STL · 762 KB
- Necklace Holder Post 1 REBD.stl STL · 67 KB
- Necklace Holder Post 2 REBD.stl STL · 81 KB
- Coupler, Necklace Holder, REBD.stl STL · 2,9 MB
- Top, Necklace Holder, REBD.stl STL · 9,5 MB
- Extension, Necklace Holder, REBD.stl STL · 7,0 MB
- Post, Necklace Holder, REBD.stl STL · 7,1 MB
- Base, Necklace Holder, REBD.stl STL · 6,2 MB
- Categoría
- Moda y joyería
- Formatos
- STL
- Descargas
- 1,308
- Publicado
Sobre este modelo
****FINALLY UPDATED to address lame design flaws**** Added threaded couplers to attach the post and post extension together and the post or extension to the top. If the coupler is too big on your print, scale it down a little in x and y. Coupler has a slot in the bottom to aid in extraction with a flathead screwdriver if necessary. The post snaps in place to the base and it seems to hold well enough. Probably should have threaded it, but didn't in this iteration. Necklace and jewelry holder for necklaces on top and rings and earrings in the base. Short - Print Post and one Extension, 2 couplers Tall - Print Post and 2X Extensions, 3 couplers
Descripción original del autor, publicada en Printables.
