Under Desk Drawer with clamp
por SevenDart en MakerWorld
Hello! My friend asked for underdesk drawer without screwing, so I've designed an organizer with a clamp, that holds organizer tight to the table.
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a SevenDart.
Archivos (9)
- BackStoppers.stl STL · 295 KB
- Clamp Press.stl STL · 7,3 MB
- Clamp.stl STL · 2,3 MB
- Drawer.stl STL · 736 KB
- LeftShield.stl STL · 1,1 MB
- RightShield.stl STL · 1,1 MB
- Shelf.stl STL · 74,8 MB
- Stabilizer.stl STL · 36,3 MB
- TestScrew.stl STL · 382 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 718
- Publicado
Sobre este modelo
Hello! My friend asked for underdesk drawer without screwing, so I've designed an organizer with a clamp, that holds organizer tight to the table.
Model contains 10 plates, but I didn't try to print everything at once, so feel free to organize it differently.
Assembly is simple enough: 1. ShelfBase is combined with shields through screws 2. Shields at the back are also combined with backStoppers through screws 3. At the bottom shields are combined with stabilizers 4. Clamp contains two parts: screw and press. Screw is screwed into the designed hole and then press is attached to the end of the screw. 5. Insert drawers onto rails and you're done!
Important note: PETG is not stiff enough, so I glued silicon picies onto parts touching table: ShelfBase and ClampPress. If you have TPU, I think it would suit better.
UPD: added a version without honeycomb pattern
Descripción original del autor, publicada en MakerWorld.
