UFO
UFO, UAP... call it what you will. It's here, and it's 3D printed!
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Devin B.
Archivos (2)
- UFO_foot.stl STL · 167 KB
- UFO.stl STL · 2,5 MB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 144
- Publicado
Sobre este modelo
UFO, UAP... call it what you will. It's here, and it's 3D printed!
This is a part from my UFO of BABYLON Puzzle (https://than.gs/m/932374), but I figured it's a fun little model on its own!
---
For the multicolor look, swap filaments at (or just above) the following layer heights: - 4mm - 5.6mm - 12mm - 13.6mm
Prusa Slicer is great for inserting filament swaps and previewing the result
---
Print 3 of the tiny 'foot' pieces. These are connected to the UFO with a piece of 1.75mm filament. I cut the ends at an angle with my filament clippers to stick them on more easily.
Filaments used in photo are: - MatterHackers Ecto Green PRO PLA (https://bit.ly/PRO-PLA) - Polymaker Lavender Purple PolyTerra Matte PLA (https://amzn.to/3r5719p) (US direct link (https://us.polymaker.com/products/polyterra-pla?_pos=1&_sid=2fb85dbd7&_ss=r&variant=39574352035897&aff=193)) - Tecsonar Tri-Color Filament Silk Red, Silk Blue, Silk Green (https://amzn.to/3Zdm0dZ)
---
That's all there is to it. Leave a comment if you have any questions. Enjoy, and keep your eyes on the skies! :)
Descripción original del autor, publicada en Thangs.
