Ubiquiti Rocket M2 and M5 Port Cover
por Don Barber en Thingiverse
A printable replacement for the cable-compartment cover on the Ubiquiti Rocket M2 and M5 (same housing). It copies the original's curved shell, rail tongues, guide tabs, two 7 mm cable notches and the snap latch. Dimensions were measured with calipers from a real M5 cover and tested on both an M2...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Don Barber.
- Categoría
- Varios
- Formatos
- MD, STL
- Descargas
- 5
- Publicado
Sobre este modelo
A printable replacement for the cable-compartment cover on the Ubiquiti Rocket M2 and M5 (same housing). It copies the original's curved shell, rail tongues, guide tabs, two 7 mm cable notches and the snap latch. Dimensions were measured with calipers from a real M5 cover and tested on both an M2 and M5. Claude was used with a lot of guidance. It prints really well with PLA but if using PETG (better with outdoor exposure) add a brim to help adhesion.
Descripción original del autor, publicada en Thingiverse.
