twigger trigger 1.2
Hooray! The better, maybe working version of the twigger trigger is finally out!
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a Jubal W.
Archivos (10)
- pusher.stl STL · 45 KB
- slide.stl STL · 313 KB
- barrel.stl STL · 198 KB
- left handle.stl STL · 13 KB
- right handle.stl STL · 13 KB
- rear iron sight.stl STL · 11 KB
- 6mm tip - blaze orange.stl STL · 24 KB
- twigger parts.stl STL · 625 KB
- twigger parts (1).stl STL · 5 KB
- twigger parts (2).stl STL · 4 KB
- Categoría
- Cosplay y props
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Hooray! The better, maybe working version of the twigger trigger is finally out! DISCLAIMER: this might not work. while I do try to account for tolerances and overhang in my designs, I don't have a 3d printer so I can't actually test these. If a user would test it for me, and post results in the comments, that would be appreciated (will not appreciate through means of Venmo, cash or whatever money you might have been hoping for, you just get bragging rights). I will try to improve upon it based on your feedback.
If it all works, you will need just a couple rubber bands, one large (for firing, routed through the notches on the pusher, then up through the slide, hooking onto the front iron sight), the other small, or you can replace the small one with a mechanical pencil spring (for the trigger, to be honest, I don't have specific instructions for this one). Then you will have a functioning top prime front loading blaster that will shoot just about anything.
The assembly video is on my cults page: https://cults3d.com/:5051135
REMEMBER TO PRINT THE 6MM TIP IN BLAZE ORANGE, AND GLUE IT ON!
Descripción original del autor, publicada en Thangs.
