Tweety

Tweety, also known as Tweety Pie and Tweety Bird, is a yellow canary in the Warner Bros. Looney Tunes and Merrie Melodies series of animated cartoons.

The name "Tweety" is a play on words, as it originally meant "sweetie", along with "tweet" being an English onomatopoeia for the sounds of birds. His characteristics are based on Red Skelton's famous "Junior the Mean Widdle Kid." Tweety appeared in 46 cartoons during the golden age, made between 1942 and 1962.

His signature lines are "I tawt I taw a puddy tat!" and "I did! I did taw a puddy tat!"

No supports are required. One piece, head, is presented as two pieces without supports and also as one piece if you want to use your slicer supports. If you have the proper filament colors, no painting is needed.

The assembled model is 105mm tall and is in proportion to my Sylvester model.

Enjoy!

...........................................................................................................

**Print Instructions:** Supports: No Resolution: .2mm Infill: 10%

Notes:**

Refer to the notes below for a few helpful printing and assembly instructions.

...........................................................................................................

**Building the model**

Colors

Black: (Paramount3D PLA - Black) hair_front hair_middle hair_back eyebrow_left eyebrow_right eyelash_1_left eyelash_1_right eyelash_2_left eyelash_2_right eyelash_3_left eyelash_3_right eye_black_left eye_black_right

..

Yellow: (Paramount3D PLA - Simpson Yellow) body head_front head_back head_onepiece (optional piece to print the head without a seam using slicer supports)

..

Orange: (Paramount3D PLA - McLaren Orange) foot_left foot_right beak

..

White: (Overture PLA - White) eye_white_left eye_white_right

..

Light Blue: (Soulutech PLA - Aqua Blue) eye_blue_left eye_blue_right

..

Any Color (hidden piece) head_pin

...........................................................................................................

**Printing and assembly tips**

Printing tips 1 - No supports are required.

2 - There are some pieces that may need brims or rafts, use your discretion. When setting up my prints I prefer to be conservative, especially since the base of many parts are hidden when inserted into another part. For the smaller parts, a good first layer is helpful.

*I used brims on: body

3 - If you can print all the small black pieces without a brim they will look and fit better. Simple clean bed adhesion is all that is required.