Tower Planter Pot
por David Payne en Thingiverse
Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has the over water drain in the lower level. If you see water there, you have watered too much. The bottom vents allow the soil to breathe. This was printed using 3D Mars Wood PLA at a resolution of 0.2..
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a David Payne.
Archivos (1)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 30,323
- Publicado
Sobre este modelo
Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has the over water drain in the lower level. If you see water there, you have watered too much. The bottom vents allow the soil to breathe. This was printed using 3D Mars Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support. 3D Mars Wood PLA and Bizard 3D Tech Wood PLA: https://amzn.to/2IwVWSr Finished with Sedona Red Minwax: https://amzn.to/2mWSszV With a clear coat of satin clear spray: https://amzn.to/2LFHgXr You can get the Minwax and Satin Clear spray from a local Home Depot. My Printer: http://amzn.to/2BBYP4t
Descripción original del autor, publicada en Thingiverse.
