Touch Grass - Hidden Phone Drawer

Put your phone away. Keep a little green in sight.

TOUCH GRASS hides your phone beneath a miniature meadow. Pull out the drawer, set your phone inside and slide it closed. The rounded grass and single daisy turn a practical phone drawer into a playful desk object.

FIVE PRINTABLE PARTS - One-piece cream housing. - Cream drawer with integrated front. - One connected green grass insert with its flower stem. - Daisy petals. - Daisy center. The grass blades are integrated into the lid, so there are no individual blades to assemble. No screws, electronics or purchased mechanism are needed. Use your preferred colors; print separately without a multi-material system.

SIZE & FIT Housing: 126 × 207 × 38 mm. Every part fits individually in a 250 mm build volume. Nominal drawer interior: 102.8 × 185 mm with rounded corners. Use a 102 × 184 mm rectangle and a maximum 18 mm phone/case thickness as a conservative starting fit check. Verify the camera bump and actual phone before printing. The drawer is removable and has no pull-out stop. Support it as you open it.

PRINT & ASSEMBLE Suggested starting point: PLA, 0.4 mm nozzle, 0.20 mm layers, three or four walls and 15–20% infill. These are starting settings, not a tested print profile. Print the housing open-top up, the drawer upright and the grass insert grass-up. Check the flower stem and small bridges for local support. Orient the petals with the flat rear hub face down; the rounded petals may need local support. Inspect the yellow center orientation and peg before slicing. Slide the drawer into the housing, seat the grass insert, then attach the petals and yellow center. Dry-fit the flower pegs before applying a small amount of suitable adhesive if needed. Do not glue the drawer or runners.