TissueRise – Vertical Tissue Box with Tray

Give your tissues a place to stand.

TissueRise turns an everyday tissue box into a decorative piece for your sideboard, bedside table, or desk. Its upright orientation keeps the footprint compact, while the ribbed front and asymmetric accent frame bring texture and character to your space.

A small tray at the front adds a handy spot for coins, rings, and other little essentials.

Design highlights

- Vertical format: holds your tissue carton upright, with tissues dispensed through the front.

- Ribbed body & accent frame: vertical lines and an asymmetric frame give the box a distinctive look.

- Integrated tray: keeps small everyday items within reach.

- Magnetic rear lid: opens easily for quick access and refilling.

- Support-free printing: all four parts print without supports using the included profile.

- No AMS required: separately printed parts let you mix and match colours for the body, base, lid, and accent frame.

Dimensions & compatibility

Overall dimensions: approximately 150 × 150 × 260 mm.

Internal space for the tissue carton, in its upright position:

- Width: 120 mm

- Height: 230 mm

- Depth: 80 mm

Front dispensing slot: approximately 127 mm high × 18 mm wide.

Designed to accommodate a range of rectangular tissue cartons within these dimensions. Please measure your carton before printing and allow a little clearance for easy insertion. Carton sizes vary between brands and countries.

The photos show the model with these Amazon own-brand tissues. I’ve also tested the fit with tissue boxes from Kleenex and Lidl, and both fit nicely.

Parts & assembly

The model prints in four parts:

- Base with integrated tray

- Tissue box body

- Rear lid

- Accent frame

The base, body, and accent frame fit together using connectors. For a permanent assembly, add a few drops of superglue to the connecting surfaces if desired.

The rear lid is held in place by 8 round magnets in total, Ø4 × 2 mm, fitted into the body and lid. Check the polarity of each matching pair before securing the magnets.

Printing & build plate preparation

The included print profile requires no supports and no AMS.

The tissue box body is printed face down, with its ribbed front facing the build plate. Please clean the build plate thoroughly before printing. This helps ensure good first-layer adhesion and a clean finish on the visible front surface.