Tiny Chess Kit-Card (compact and modern 3D puzzle set)
por GlennovitS 3 en Thangs
My first ever kit-card design - chess pieces as a kit-card! Prints all flat - and then you have to assemble the set. As this is my first attempt on kit-cards, please feel free to comment with suggestions for future improvements. And enjoy!
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicionesStandardDigitalFileLicense
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a GlennovitS 3.
Archivos (17)
- Tiny Chess Kit-Card.3mf 3MF · 842 KB
- Bishop Kit-Card.stl STL · 297 KB
- Chess Kit-Card - Pawns.stl STL · 843 KB
- Chess Kit-Card - Special pieces.stl STL · 1,0 MB
- King Kit-Card.stl STL · 185 KB
- Knight Kit-Card.stl STL · 242 KB
- Pawn Kit-Card.stl STL · 180 KB
- Queen Kit-Card.stl STL · 215 KB
- Rook Kit-Card.stl STL · 236 KB
- Bishop Kit-Card - Tight.stl STL · 297 KB
- Chess Kit-Card - Pawns - Tight.stl STL · 843 KB
- Chess Kit-Card - Special pieces - Tight.stl STL · 1,0 MB
- King Kit-Card - Tight.stl STL · 185 KB
- Knight Kit-Card - Tight.stl STL · 242 KB
- Pawn Kit-Card - Tight.stl STL · 180 KB
- Queen Kit-Card - Tight.stl STL · 215 KB
- Rook Kit-Card - Tight.stl STL · 236 KB
- Categoría
- Miniaturas
- Formatos
- 3MF, STL
- Descargas
- 54
- Publicado
Sobre este modelo
My first ever kit-card design - chess pieces as a kit-card! Prints all flat - and then you have to assemble the set. As this is my first attempt on kit-cards, please feel free to comment with suggestions for future improvements. And enjoy!
Overview
The kit contains all default chess pieces: - King - Queen - Bishop - Knight - Rook - Pawn You can print them individually OR as bigger ‘sets’ in a single card!
Assembly
This should be fairly simple as all pieces only contains 3 elements: - Snap/cut the elements free from the card - Slide the 2 main elements together (one from the top, and the other from the bottom) - Press the assembled piece down into the base (tip: do it while the base is flat on a table) If the fit is too loose, maybe a little glue can help. If it’s too tight, maybe a little sanding..
Print instructions
Here is a few suggestions: - Speed: Low 1. layer speed (maybe below 50% of normal - just the first layer to ensure bed adhession with all the small lines) - Orientation: The cards should be oriented correctly - Brim: No. Would take a long time to clean the model..
Happy printing!
Descripción original del autor, publicada en Thangs.
