TILT PHONE STAND
por Matthew Ghost en MakerWorld
NEW IMPROVED VERSION TILT PHONE STAND 🥳. The stand allowing you to comfortably and securely hold your mobile phone at the optimal viewing angle.
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Matthew Ghost.
Archivos (5)
- 01_Base.stl STL · 118 KB
- 02_Gear_Stand_Left.stl STL · 225 KB
- 03_Gear_Stand_Right.stl STL · 228 KB
- 04_Gear_Additional.stl STL · 140 KB
- 05_Gear_Control.stl STL · 180 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 58,030
- Publicado
Sobre este modelo
NEW IMPROVED VERSION TILT PHONE STAND 🥳
The stand allowing you to comfortably and securely hold your mobile phone at the optimal viewing angle.
- Designed for printing completely without supported!
- You will need glue (Superglue for plastics). It is necessary to connect the parts (02_Gear_Stand_Left + 03_Gear_Stand_Right) together.
- Its possible that the gap between the base and the tilt gear will be too large. This will cause a slip. To prevent slipping, I recommend sticking the electrical tape on the guide (Base). Or you can also add a layer of glue on the contact surface and let glue dry.
- Otherwise, if the connection is too rigid, it is necessary to grind the contact surface.
Descripción original del autor, publicada en MakerWorld.
