Threaded filter cap for Can-Am G2 Waterproof
por Mariusz Maciuk en Thingiverse
Threaded filter cap for Can-Am G2. Print at an angle of approximately 30 degrees. Using ASA-CF filament is recommended. The cap is designed for a 120x3.5 mm O-ring. It is not suitable for OEM filters; it is intended for aftermarket filters.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Mariusz Maciuk.
Archivos (2)
- Categoría
- Varios
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Threaded filter cap for Can-Am G2. Print at an angle of approximately 30 degrees. Using ASA-CF filament is recommended. The cap is designed for a 120x3.5 mm O-ring. It is not suitable for OEM filters; it is intended for aftermarket filters.
Descripción original del autor, publicada en Thingiverse.
