Thin Desktop Phone Stand – Minimal & Support-Free
Great for Workspaces - No Supports Needed - Fits Most Phones with Cases
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a Stray D.
Archivos (1)
- Thin Stand v1.stl STL · 250 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 289
- Publicado
Sobre este modelo
Great for Workspaces - No Supports Needed - Fits Most Phones with Cases
This is a simple but sturdy phone stand I designed for my own desk setup. It holds your phone at a comfortable viewing angle and prints flat without any supports. The design is clean and low-profile, but stable enough for everyday use. - Holds most phones with cases - Front lips keep the phone from sliding off - Good viewing angle (about 60 degrees) - Support-free, easy print - Designed to sit solidly on any desk
Print Info:
Orientation: Flat
Layer Height: 0.2mm
No supports
Works well in PLA or PETG
I designed this for myself, and it worked so well I figured I would share it.
Descripción original del autor, publicada en Thangs.
