Thermoformed Christmas Star | Candy Container

Part of the same thermoform holiday set as the Christmas Lights, Christmas Tree, and Candy Cane containers — same hinge pin, same shared Cap design. Hang a six-point star on the tree with this thermoformed Christmas Star container ⭐

Print two flat mesh sheets, heat them, and press them into the included mold with the push to form two puffy, faceted star halves. Join the halves at the bottom point with the hinge pin, then screw on the cap at the top point, which doubles as the hanging loop. This Toon profile prints the star yellow with white facets arranged in a pinwheel across both halves, for a clean cel-shaded look, and the hinge pin prints yellow right along with the sheets.

The push on this one is deep — a straight wall, a chamfer, and a faceted pyramid running up to the peak — so each half holds a real amount of candy, not just a token handful. The mesh lets whatever you fill it with peek through, which is really what sells it as a gift.

Perfect for:

- Filling with candy and hanging it on the tree

- Stocking stuffers and secret santa gifts

- Mantel or shelf decor through the season

- A small gift presentation that skips the wrapping paper

🛠️ Printing Notes

- No supports needed anywhere — sheets print flat, mold prints cavity up

- Sheet plates come in Gyroid, Honeycomb, and Triangles infill — each plate has both halves plus the hinge pin

- Mold and Push print best in PETG

- Cap prints on its own plate and is shared across the whole thermoform set

Happy printing 🎄