Thermoformed Christmas Ornament | Nordic

The Christmas thermoformed series keeps going — same mold as the snowflake and reindeer versions, so the mold you already printed still works! https://makerworld.com/en/models/3424683-thermoformed-christmas-ornament-reindeer#profileId-3903110

Bring a bit of Nordic sweater warmth to the tree this year ❄️

Two mesh halves print flat, form over the mold, and close into a full round ornament — hollow inside, with a white folk-knit band running across the face: zigzag rows, little dot borders, diamonds, and a star snowflake sitting right in the middle. The printed cap on top gives it the classic ornament crown and somewhere to run a ribbon, a hook, or a bit of twine.

The mesh keeps the whole thing light enough to hang off a real branch while still catching light from every angle, and the white pattern stays crisp against whatever body color you pick. Green with white is the folk-knit look, but red, cream, or blue work just as well.

Perfect for:

- Tree ornaments in whatever color combo you like

- Scandinavian and farmhouse holiday decor

- A small gift with candy or a note hidden inside

- Gift tags tied onto a wrapped present

- Garland, mantel, and holiday table decor

🛠️ Printing Notes

- Prints flat, no supports

- Mold and push block in PETG, ornament halves in PLA

- The printed pin holds the two halves together

- Use even heat when forming so the mesh keeps its shape

- The mold is shared across the series — print it once and reuse it for the other ornaments Light, round, and quietly festive — the Nordic one joins the set. Happy printing 🎄