Thermoformed Christmas Ornament | Harlequin

The Christmas thermoformed series continues — same mold as the Snowflake ornament, so if you printed that one you only need the halves! https://makerworld.com/en/models/3384600-thermoformed-christmas-ornament-snowflake#profileId-3851406 Dress the tree in a classic diamond pattern with this thermoformed harlequin ornament 🎄 Two mesh discs print flat, form over the dome mold, and clip together into a full round ornament — hollow inside, with a white diamond lattice wrapping over the whole ball and a little white dot sitting in every diamond. The printed cap and ring on top finish it off and give you somewhere to run a hook or a ribbon. The open mesh keeps it light enough to hang off a thin branch while the tree lights glow straight through from behind. Green and white is what I printed; the project file ships red and white like the rest of the series, so swap in whatever fits your tree. Perfect for:

- Tree ornaments in your own color pairing

- Hiding a small candy or a folded note inside

- Gift tags on a wrapped present

- Garland, wreath, and holiday table decor

- Stocking stuffers and secret santa fillers

🛠️ Printing Notes

- Prints flat, no supports

- Mold and push block in PETG, ornament halves and cap in PLA

- The pin is tiny — print it with the rest so you don't lose it

- Use even heat so the mesh keeps its shape while forming

- Same mold as the Snowflake, so keep it around for the next one

Light, round, and festive — the harlequin joins the set. Happy printing 🎄