Tamiya ORV Rear Suspension Bushing
por Joshua Fannin en Printables
A simple bushing to take up slack in ORV swing arms
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Joshua Fannin.
- Categoría
- Varios
- Formatos
- STEP
- Descargas
- 0
- Publicado
Sobre este modelo
I made these to replicate what I think was probably a CRP part at one time. This bushing goes in the hole in your transmission case and takes up the slop that the trailing arms usually exhibit. Not a new idea, but I wanted to use them in my latest builds. There are two sizes, as I found that one of my transmission cases had a smaller opening in it. The small one is around 11.5mm, and the larger is closer to 13mm.
Descripción original del autor, publicada en Printables.
