T-Handle Bit Driver — Magnetic 1/4″ Bit Holder
por 3Dwake en Printables
magnetic Hand bit driver
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a 3Dwake.
Archivos (2)
- Categoría
- Herramientas
- Formatos
- 3MF, STL
- Descargas
- 28
- Publicado
Sobre este modelo
Keep a useful bit driver close at hand. This compact T-handle gives you a cross-grip for light manual tightening and uses common 1/4-inch hex screwdriver bits. Assembly
The round magnet sits in a pocket at the bottom of the hex socket, behind the bit. The magnet must be glued in place. Use a round 5 mm diameter × 2 mm thick magnet. Apply a small amount of two-part epoxy or cyanoacrylate (super glue) in the magnet pocket or onto magnet. Let it cure fully before inserting a bit. The magnet helps retain the bit; the hex walls transfer turning force.
share your prints in the comments!! --3Dwake
Descripción original del autor, publicada en Printables.
