T-800 Single and 3 Piece High Detail Head

Come join our Patreon! For a few years now I have been building up a large collection of busts, cosplay, props and all sorts of models that were made for the Patreon page, if you would like to check out the models that some of the 400+ members are enjoying printing, please join our facebook group! https://www.facebook.com/groups/333491834120262/ Currently all new members receive access to the older models released, so we are talking suits, Full scale prints (like 1:1 scale articulated Droideka...) helmets, detailed busts and dioramas all for the low subscription of $10 a month. If you think this might be for you, please click on the link below or through the facebook page. https://www.patreon.com/Geoffro Updated Fixed the Jaw sitting flat on the plate (if it's not flat still for you, use the lay flat feature - in makerware its flat on layer 0.1.) also added the full 38mb hi-res skull as requested. I have made the pipes Fatter! I was tired of them being too weak when printed small, so I increased the thickness of all the pipes by 2mm. This is a remix of my other smoothed T-800, which was remixed from ToScH's one, but I went a bit further this time. I made it even higher res, with more detail (literally sculpted out pieces) and then split it into 3 pieces, but they were split for printing specifically with little supports and to fix areas where a full print can fail, like the mouth/jaw pipes. Now you can print them the other way around. I also cut the slices so they would not interfere with the facial geometry. I removed all the supports that were under the chin so it's as is now, so you could print it upsidown or normally, up to you. I cut the back of the cranium out so you can put led lights in easily to the eyes. If the like button gets clicked enough I might even cut out the eyes and make them all seperate and also add the CPU core screw cap :)