Swing-Out Spool Holder for IKEA SKÅDIS
por DELLOO2008 en Printables
Store a filament spool flat against the board, then swing it out 90° so it can feed a printer. Not tested yet.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a DELLOO2008.
Archivos (2)
- Categoría
- Organización
- Formatos
- STEP, 3MF
- Descargas
- 20
- Publicado
Sobre este modelo
One holder, two positions. Closed: the spool sits flat in front of the board with the label facing you. Swung out: the arm turns 90° and the spool sticks straight out so it can spin and feed a printer. NOT TESTED: this design has not been printed yet. - Hinge with a printed pin and a click into both positions (0° and 90°)
- 50 mm axle for spools with a 52–58 mm hub hole (such as Bambu Lab spools)
- Small barb on the axle keeps the spool from sliding off
- Two clips slide into the base and hook into the pegboard
Descripción original del autor, publicada en Printables.
