Subaru Forester Seat Track End Cap - thicker for FDM
por JC en Printables
A simple remix that thickens some areas of the cap so it has more layer adhesion surface. Should fit 2021 - 2025.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a JC.
Archivos (2)
- Categoría
- Repuestos
- Formatos
- STEP, 3MF
- Descargas
- 0
- Publicado
Sobre este modelo
A simple remix that thickens some areas of the cap so it has more layer adhesion surface. I recommend printing it with supports and the cross bar on the bed surface. (The same orientation you install it on the seat track. The sides need to flex to snap in, and can break at a layer if printed face down.) It should fit 2021 - 2025 Foresters, and probably any Subaru that uses the square bottom seat tracks. Thanks to 0ned0llar for the original and including the .step file, which made this remix possible.
Descripción original del autor, publicada en Printables.
