Storage Tube with Threaded Lid and Seal Recess
por filiafeskin en Cults3D
A ribbed storage tube with a twist-on lid and a built-in feature for sealing it the old-fashioned way. A special recess on the closed tube is filled with modeling clay or wax, then stamped with a seal or a signet ring. The moment the lid is opened, the imprint is destroyed, so you can immediately...
Cults3D entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalLicencia de uso privado de Cults3D: puedes imprimirlo para ti. No se permite compartir el archivo ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a filiafeskin.
Archivos (1)
- Storage Tube_XXL.3mf 3MF
- Categoría
- Hogar
- Formatos
- 3MF
- Descargas
- 2
- Publicado
Sobre este modelo
A ribbed storage tube with a twist-on lid and a built-in feature for sealing it the old-fashioned way. A special recess on the closed tube is filled with modeling clay or wax, then stamped with a seal or a signet ring. The moment the lid is opened, the imprint is destroyed, so you can immediately see that the tube was opened.
Features
Built-in recess for a clay or wax seal on the lid and the body
The seal is destroyed when the tube is opened
Threaded connection
Ribbed (fluted) surface that gives a good grip for twisting the lid open
Prints in 2 parts, supports are not required
Works with a custom stamp, a numbered seal, or a signet ring
Size
Height: 104 mm
Width: 75 mm
Length: 70 mm
Maximum seal size: 32 mm in diameter
How to seal it
Screw the lid on fully.
Fill the recess where the lid meets the body with modeling clay.
Press your stamp or ring into it to leave an imprint.
To open, twist the lid. The seal is destroyed. To reseal, smooth the surface of the clay and press a new imprint.
Note: This is a tamper-evident seal, not a lock. It shows whether the tube was opened, but it does not prevent opening.
Descripción original del autor, publicada en Cults3D.
