Stinkbug: 1 lb PLAnt Robot for the Repeat Open PLAnt Challenge
por Hyrum en Thingiverse
This was my design for the Repeat Robotics PLAnt challenge. It's a vertical drum spinner using the Repeat Open Plant Bundle. You can find this kit bundle at the following link: https://repeat-robotics.com/products/open-plant-bundle. Print Settings: Main Body: 5 walls, 10 % infill Lid: 5 walls, 10 %.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Hyrum.
Archivos (6)
- Categoría
- Para tu impresora
- Formatos
- STL, ZIP
- Descargas
- 0
- Publicado
Sobre este modelo
This was my design for the Repeat Robotics PLAnt challenge. It's a vertical drum spinner using the Repeat Open Plant Bundle. You can find this kit bundle at the following link: https://repeat-robotics.com/products/open-plant-bundle. Print Settings: Main Body: 5 walls, 10 % infill Lid: 5 walls, 10 % infill Forks: 6 walls, 30% infill Weapon: 10 walls, 100% infill Hubs: 5 walls, 10 % infill All 3D printed parts are PLA + No supports are needed 3D Printed Parts Weight Estimate: Body: ~108.0g Lid: ~25.8g Forks: ~19.2g (for both together) Hubs: ~21.5g (for both together) Weapon: ~29.7g Total: ~204.2 Electronics Weight Estimate: Weapon Motor: ~46g Drive Motors: ~54g (for both together) Battery: ~32g Drive ESC: ~6g Weapon ESC: ~7g Total: ~145g Grand Total: ~ 349.2g
Descripción original del autor, publicada en Thingiverse.
