Steam Frame Dongle/Wireless Adapter Cap Holder

A press-fit holder to keep your Frame dongle cap with your dongle while it's in use. Designed to be printed without supports. It is recommended to print with a brim or mouse ears. A flat bottom version without a bottom chamfer is available if bed adhesion is still a problem. The part was nominally dimensioned to what I measured on my dongle, so adjust X-Y hole compensation and X-Y contour compensation as needed for good fit. (Use hole compensation to adjust fitment on the adapter, use contour compensation to adjust fitment on the cap.) Rev4 of the model includes indents for positive retention on the cap. Edit 09/28/26: Slots were added to the "tines" to avoid wearing out the nubs on the inside of the cap during use per jay890y's suggestion. This also makes the cap fit looser, so you will probably need to adjust X-Y contour compensation to be bigger in order to fit. If there are issues with fitting both sides I'll probably revise the model. Edit 2 09/28/26: After thinking more about it, I decided to add a indent towards of the bottom of the slots. These allow the detent on the insides of the cap to click in and positively retain the cap to the clip.