Steam Controller (2026) HSW Charging Dock
por Arkadiusz Chyliński en Printables
HSW-mounted Steam Controller (2026) dock with a slot for the charging puck.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Arkadiusz Chyliński.
Archivos (1)
- Categoría
- Organización
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
A wall-mounted charging dock for the Steam Controller (2026), designed for RostaP’s Honeycomb Storage Wall (HSW). The cradle follows the shape of the controller, and the original magnetic charging puck sits in a recessed pocket. Printing Print the dock upright with the wide end on the build plate, as shown in the slicer screenshot. Use supports under the rear HSW mount and the top edge of the puck recess. Without support, that edge may sag and affect how the puck fits. Depending on your printer and filament, you may need to lightly file the puck recess or the lower lip that supports the controller. Assembly - Seat the puck in the provided recess, then plug in the USB-C cable. It should fit firmly into the print.
- Route the cable and fit the dock to your HSW panel.
- Place the controller on the dock and check that it starts charging. If it does not, most likely the bottom lip printed too high or the puck sits too low.
The dock is designed for the original USB-C cable. Its plug should fit snugly in the cable opening and help keep the puck in place.
Descripción original del autor, publicada en Printables.
