Statue of Nocturnal from Elder Scrolls Online
por VoxInaudita en Printables
This is a model taken from the Elder Scrolls Online with some smoothing applied.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo sin pedir permiso ni dar crédito.
Al descargar aceptas respetar la licencia y dar crédito a VoxInaudita.
Archivos (10)
- 01-base-front.stl STL · 3,2 MB
- 06-left-sleeve.stl STL · 1,7 MB
- 08-left-hand-and-bird.stl STL · 3,9 MB
- 09-right-hand-and-bird.stl STL · 4,0 MB
- 07-right-sleeve.stl STL · 2,1 MB
- 02-base-back.stl STL · 2,8 MB
- 03-middle-lower.stl STL · 8,5 MB
- 05-head-and-chest.stl STL · 13,0 MB
- 04-middle-upper.stl STL · 19,2 MB
- statue-of-nocturnal-eso.stl STL · 33,6 MB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 1,999
- Publicado
Sobre este modelo
This is a model taken from the Elder Scrolls Online with some smoothing applied.
This model is available as one whole piece which is 170 mm high, or split into parts that assemble into a statue about 40 cm (15.8 inches) high. The statue has been designed with a hollow base to stash your trinkets in.
Printing with a brim is highly recommended. Both versions need supports to print and have very fragile points at the legs of the birds. The birds on the whole version will almost certainly come off with the supports and need to be re-attached. Handle with care!
Print instructions Supports are necessary for all parts.
A 5 mm brim was used on most parts.
3 perimeters were used on the parts with the birds.
Descripción original del autor, publicada en Printables.
