Stackable /Stacked LEGO Brick Sorter / Sorting Box (Updated & Mini Version)

Newest Edit: 6-10-2024 New version follows the same concept as before but now the lid closes completely in both stacked and unstacked positions. Plus rounded edges for the little ones. Includes faster print time (albeit still takes a fair while to print to give good structure for shaking) Also added a mini version for printers like the Prusa Mini - 175mm x 175mm print bed usage.

Older Edit: There's now a version for those with a Prusa Mini or similar small build plate printers. You can find it here. We've also uploaded a modified version which takes less time to print, has no text and uses less filament due to slightly thinner perimeter walls (2mm vs 3mm). The lack of text is not needed as the sides of each unit has a placement indent guide as shown below.

Original Text:

We previously built our first iteration of the LEGO Sorting Shaker. It was pretty good and people found it useful, but we've supercharged it with this model.

Not only does it work better due to revised hole diameters, it's also stackable when in use and can nest within itself when not in use! We've written a full review of the use of the sorter on our blog, so check it out for more info such as the cost/print time etc. You can read more about it here.

Use supports for printing to allow for the lip. Infill at 20% is fine. PLA or PETG are both very effective.

You can see it in action below: