Stackable Phone Organizer with Mesh Lid

A compact modular organizer for storing phones flat on your desk. Print the same tray module as many times as needed, stack the layers, and add the matching removable mesh lid. Files and quantities • phone-tray.stl — print 3 copies for three phones. • lid.stl — print 1 copy for the top. Dimensions • Internal width: 82 mm; usable tray depth: 150 mm. • Clear height between shelves: 18 mm; stacking pitch: 20 mm. • Tray maximum dimensions: 90 × 152 × 23 mm, including the locating pegs. • Three trays plus lid: approximately 65 mm tall. • Central rear cable opening: approximately 22 × 16 mm on the lower layers. The tray is intentionally shorter than larger phones, allowing the front end to extend out for easier removal. A finger recess helps with shorter phones. Check your phone case width and total thickness, including the camera bump, before printing. The floor and lid have matching rounded rectangular openings; both sides and the rear are perforated. Four locating pegs align the layers. The joints are removable, not locking clips: support the bottom when moving the assembled organizer. Printing Print trays with the floor down and locating pegs up. The lid STL is already oriented with its exterior face down and sockets up. Designed to print without supports; inspect your slicing preview. Suggested starting settings: 0.4 mm nozzle, 0.2 mm layer height, 3 walls. PLA is suitable for indoor desk use; PETG is another option for greater toughness. Fit depends on your printer and material: test one tray before printing the whole stack.

中文说明 模块化手机收纳盒，同一种托盘重复打印后上下堆叠，配独立镂空顶盖。三层需要盒子打印三份、顶盖打印一份。内宽82 mm、可用深度150 mm、层间净高18 mm，三层加盖约65 mm。背部中央留有走线口，底板、侧面及顶盖镂空省料。请核对带壳后的宽度与包括摄像头在内的厚度，先试打一层确认接口松紧。搬动整组时托住底部。