Springo Skull
What a spooky Springo!
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Devin B.
Archivos (1)
- springoskull.stl STL · 8,2 MB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 259
- Publicado
Sobre este modelo
What a spooky Springo!
Print at .15mm layer height and separate spring manually after printing. No supports required!
100% infill is recommended. Results vary by slicer, but basically make sure the layers above and below the small Springo gaps are printing solid (Simplify3D recognizes these as top and bottom layers so you can use a lower infill, but Cura won't recognize the layers as top/bottom, and therefor prints infill instead of solid).
You can use a glow-in-the-dark filament like Polymaker Blue Glow PLA (https://amzn.to/3KtK8mB) for a cool effect!
This is a remix of the "Low Poly Skull" by slavikk on Thingiverse (https://www.thingiverse.com/thing:906562)
Relevant Video (https://www.youtube.com/watch?v=hMAgMDgi7xQ) + Updated Video for making Springos (https://youtu.be/4llDtownD4s)
Descripción original del autor, publicada en Thangs.
