Springo Cactus Trichocereus
Relevant Video (https://youtu.be/22x4aALI0VE?t=635)
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Devin B.
Archivos (7)
- cactus-noflower-nospringo.stl STL · 4,5 MB
- cactus-noflower.stl STL · 12,4 MB
- cactus-wflower-nospringo.stl STL · 4,3 MB
- cactus-wflower.stl STL · 9,6 MB
- dirt.stl STL · 301 KB
- flower.stl STL · 6,3 MB
- planter.stl STL · 519 KB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 324
- Publicado
Sobre este modelo
Relevant Video (https://youtu.be/22x4aALI0VE?t=635)
Who doesn't want a jiggly plant? Here's a fun Springo cactus that prints in several parts.
The cactus screws onto the planter and holds the dirt in place as well. Use glue or a 3D pen to attach the flower. Optionally, add 1.75mm filament pieces to the blossom to create stamen.
---
I had success printing at 0.16mm layer height, 4 shells, 9 top and bottom layers (you want the spiral to be solid for maximum strength!)
After printing, carefully separate the layers using a thin tool like your print removal spatula.
---
The cool gradient effect is thanks to MatterHackers Quantum PLA (https://bit.ly/quantumPLA)
Non-Springo versions also included if you don't wan't a Springo for some crazy reason! :P
Descripción original del autor, publicada en Thangs.
