Spiral Ornament by PRNTR3D - Super Easy Print - Vase Mode
por PRNTR3D en Printables
A very easy but amazing to look at, and strong spiral ornament. The tips wont break off with this model :)
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a PRNTR3D.
- Categoría
- Figuras y arte
- Formatos
- STL, 3MF
- Descargas
- 7,631
- Publicado
Sobre este modelo
Dont forget to post your makes! I use the following settings to print this model with a hole for hanging: - Orientation: Top - Brim: 5mm - Mode: Vase - Bottom layers: Enough to get two layers into the spiral, about 40 for 0.3mm or 60 for 0.2mm layer heights. This only costs an additional 2-3 grams of material. - Cooling: set lowest speed to 3mms
The stl file is scaled to 120mm in height and 58mm in both X and Y dimensions, but the 3mf file is not. You can adjust the scale according to your preference. I have printed them at 12% scale and they worked well.
Descripción original del autor, publicada en Printables.
