Spiderweb Wind-Spinner (Ball Bearing Mod)

Spiderweb Wind-Spinner (Ball Bearing Mod)

The next special ball bearing wind-spinner which fits my windmill collection: The 2-way spinning cobweb windmill with a themed tail-blade and a spider nut.

- Unique Wind-Spinner with a Halloween themed Spiderweb Propeller Design

- Self adjusting to wind direction with the “Tail Blade”

- Super smooth spinning through the 608 ball bearing

- Counter-rotating propellers

- 3 Propeller sizes are provided as print profiles, each which left & right spinning direction

- Rods are stack able to your needed height

Boost MeTip: Smoth the axle with sandpaper and you can add some grease or oil for smooth horizontal rotating.

Info: The giant H-Version has also an larger sized "tail" and a larger rod

The Axle is designed for 2 propellers (10mm) and 1 distance. Each propeller need one 608 ball bearing The protective caps are optional

- CLAMP for Windmills

Assembly: Push the 608 ball bearing completely in both propellers The cap is optional! Carefully glue the protective washer to the edge. Be careful not to glue the inner part of the ball bearing. Glue the shaft to the axle Insert the forst propeller to the axle and add the distance ring Insert the second propeller and check if both spin smoothly Use the spider nut on top Insert the tail Prepare the stackable rod with the spike Congratulations 🎉

Thanks to all followers and don't forget the virtual handshake 👍 ….Happy Printing😉

Commercial license you can get here on Makerworld (Profile on Desktop) or on Patreon: https://www.patreon.com/BamBamDesign/