Spice Rack 1,4,6,&7
por Ken Keller en Thingiverse
Just like original. Only changes were I made a single, 4 hole, 6 hole and 7 hole racks. The Mounting tap that I had originally used did not last into the summer. I ended up moving the racks over into a pantry with a smaller door. Also added 2 that the center sections are a bit larger then the...
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Ken Keller.
Archivos (8)
- Door_Spice_Holder_1.stl STL · 75 KB
- Door_Spice_Holder_4.stl STL · 193 KB
- Door_Spice_Holder_7.stl STL · 585 KB
- Door_Spice_Holder_6.stl STL · 247 KB
- Door_Spice_Holder_2.stl STL · 138 KB
- Door_Spice_Holder_5.stl STL · 271 KB
- Door_Spice_Holder_6-_4_offset_and_larger.stl STL · 577 KB
- Door_Spice_Holder_7_Differnet_size_inside.stl STL · 432 KB
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 21,653
- Publicado
Sobre este modelo
Just like original. Only changes were I made a single, 4 hole, 6 hole and 7 hole racks. The Mounting tap that I had originally used did not last into the summer. I ended up moving the racks over into a pantry with a smaller door. Also added 2 that the center sections are a bit larger then the outside two holders. This allows you to put screws on the outside two and mounting tape on the inside ones.
Descripción original del autor, publicada en Thingiverse.
