Speed Boat 2 RC
por Michael Christou en MyMiniFactory
My first speed boot
Licencia
Solo uso personalMyMiniFactory - Credit - Remix - Noncommercial
Licencia de MyMiniFactory: puedes imprimirlo y remezclarlo dando crédito, sin fines comerciales.
Al descargar aceptas respetar la licencia y dar crédito a Michael Christou.
Archivos (23)
- Cam Mount.stl STL
- Coupling 0 5 Mm.stl STL
- coupling.stl STL
- Deck Back 116Mm.stl STL
- Deck Back 179 Mm.stl STL
- Deck Front 117Mm.stl STL
- Deck Front 169 Mm.stl STL
- Deck Interface.stl STL
- Deck Middle 116Mm.stl STL
- Hull Back 149 Mm.stl STL
- Hull Back 160Mm.stl STL
- Hull Complete.stl STL
- Hull Front 116 Mm.stl STL
- Hull Front 94 Mm.stl STL
- Hull Interface Solid.stl STL
- Hull Middle 149 Mm.stl STL
- Hull Middle 160Mm.stl STL
- Lipo Mount.stl STL
- Motor Mount.stl STL
- Rudder Horn 4 3.Stl STL
- Rudder Mount.stl STL
- rudder.stl STL
- Servo Mount.stl STL
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 1,118
- Publicado
Sobre este modelo
My first speed boot was enlarged bit by bit of three different parts. This time it should be a hull as if made from one piece with no need of spay rails. Additional it has a deck now to protect electronics. If you seal it with elastic tape and use a compensator grommet for the rudder steering rod it can be unsinkable, but I hope there is no need ;-) The overall length is 414mm. The camera mount is provided for this case for mini cam. And yes, this time we didn't need the helping hand of this beautiful mermaid, because I decided to design a flexible coupling instead of the heat shrink tubes. Update: I uploaded smaller hull parts with hight 149mm. The shortest possible hight I could make is 127mm.
Update 7.July 2015: I uploaded smaller deck parts with hight 116mm and 117mm
http://youtu.be/WKB13EdQD4Y http://youtu.be/e6QYdzF0Z5E
Descripción original del autor, publicada en MyMiniFactory.
