Spearhead Sand & Bone Terrain Box Insert - 2-Part Organizer

Spearhead Sand & Bone Terrain Box Insert - 2-Part Organizer Keep the six terrain pieces and cards from Warhammer Age of Sigmar – Spearhead: Sand & Bone (Sand & Knochen) organised in their box. This two-part insert has shaped pockets for the walls, fences, altar and pillar, plus a rectangular card pocket with a finger opening. The halves fit a 225 x 225 mm print bed and join using two concealed puzzle tabs underneath the floor. Narrow neighbouring pockets are connected locally for extra clearance. The terrain itself is not included in the download. Dimensions and features - Assembled size: 295 x 208 x 40 mm, designed for a 297 x 210 mm box interior. - Pocket depth: 36 mm. - Left print: 158.5 x 208 x 40 mm including tabs. - Right print: 147.35 x 208 x 40 mm. - About 2.5 mm or more clearance around the photo-derived terrain outlines; outer walls are at least 2 mm. - The concealed tabs are 1.6 mm high. Their sockets are 1.9 mm deep with 0.3 mm clearance. The cover photo shows the real printed insert in use. The other photographs show the original terrain used as design references. Printing Print one of each STL at 100%, in millimetres, flat side on the bed and pockets facing upwards. Both files are already oriented for printing. Suggested starting settings: PLA, 0.4 mm nozzle, 0.20 mm layers, 3-4 walls, 5 top/bottom layers and 12-15% infill. A 5 mm brim fits on a 225 x 225 mm bed. Use your filament's temperature profile. The two downward-facing sockets in the right half require bridging over roughly 16.6 mm. Check the slicer preview; use removable build-plate supports only inside these sockets if your bridging profile needs them. Remove them completely before assembly. The open pockets need no supports. Place the left half flat, align the right half above the tabs and lower it into place. For the best stability, glue the two halves together along the centre seam using an adhesive suitable for your printed material. Dry-fit the joint before applying glue. Remove any elephant foot from the tabs carefully rather than scaling the whole model. Files and fit check Two STL files, editable OpenSCAD source and an A4 paper fit template are included. Print the paper template in landscape at actual size / 100%, without fitting to the page; its control line must measure 50 mm. Dimensions of the terrain pockets were estimated from photographs calibrated against A4 paper. Compare your terrain and box before printing. An independent storage accessory compatible with the named set. This download contains the organiser, not the original terrain models. Warhammer Age of Sigmar is a trademark of Games Workshop Limited. This independent project is not affiliated with or endorsed by Games Workshop. More Snappy DIY projects, videos and links: https://linktr.ee/snappydiy Printed one? Share a Make and tell me how it fits your box.