Sonelle, Wave Slots Cylinder Lamp

Sonelle Pointed slots run down this cylinder in columns, and their lengths rise and fall from one column to the next like a wave. No slot runs from top to bottom: short bars break every column. On the top, the slots fan out from the centre and run over the edge. The slots are cut clean through the wall, so with the light on, only the slots glow. For a desk, a shelf or a bedside table. Runs on a 60 mm USB LED light kit and twists and clips together without glue or screws. Swap the glow The colour comes from the Diffuser, a thin insert printed in Spiral vase. Print a few in different colours: pull the Sleeve gently off the Lock ring, swap the Diffuser and clip the Sleeve back on. The lamp in the photos has a pink Sleeve, shown with two Diffusers: a blue one for the cyan glow and a green one for the green glow. One size You will need One 60 mm USB LED light kit (USB, 5 V). Printing Two plates: - Base and Sleeve: the Base, the Lock ring and the Sleeve.

- Diffuser - Vase mode: the Diffuser, already set to Spiral vase on the plate.

The settings are already in the files. Printing from your own profile? Use these: - Wall generator: Arachne, for every part.

- Diffuser: Spiral vase.

- Sleeve: 3 walls, wall order outer/inner.

- Base and Lock ring: concentric top surface, 7 % gyroid infill.

- Supports: off.

Print the Diffuser in a light or translucent filament, so the glow comes through. Assembly - Drop the LED light into the Base and lead the cable out through the slot.

- Twist the Lock ring onto the Base until it stops.

- Push the Diffuser onto the Lock ring.

- Clip the Sleeve onto the Lock ring, over the edge that runs around it.

Parts Base, Lock ring, Sleeve and Diffuser.