Sometimes Light Lock
por Brad Martin en Thingiverse
A lot of the light switch locks out there are to keep you from EVER turning it off. In this case, I only want to prevent turning off the switch if I have a 3D print in progress. You can put both mounts on the faceplate, but the top one sort of gets in the way, so I put it below (Because it is an...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Brad Martin.
Archivos (3)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
A lot of the light switch locks out there are to keep you from EVER turning it off. In this case, I only want to prevent turning off the switch if I have a 3D print in progress. You can put both mounts on the faceplate, but the top one sort of gets in the way, so I put it below (Because it is an unfinished wall). Quickly made with Claude and OpenSCAD because I kept killing my prints by turning off the switch on the way out (One switch for entire basement).
Descripción original del autor, publicada en Thingiverse.
