Soldering Clamp
por TheCraftyMaker en Thangs
Recommended infill:
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a TheCraftyMaker.
Archivos (5)
- Base Flat.stl STL · 613 KB
- Arm 90 Straight.stl STL · 457 KB
- Pivot Male.stl STL · 108 KB
- Pivot Female.stl STL · 85 KB
- Clamp Holder.stl STL · 63 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 347
- Publicado
Sobre este modelo
Recommended infill:
Arms and base: 20% Pivot joint and clamp holder: 40% All parts can be printed without support.
The hole for the clamp is intentionally thight. The best way to put the clamp in the holder is to heat it up. This way the plastic will melt a bit and secure the clamp.
All joints are connected using M5 bolts and nuts.
_ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription._
Descripción original del autor, publicada en Thangs.
