Solder Spool Holder
por Joshua Marshall en Thingiverse
This is a solder spool holder for 200g - 250g spools with 20mm spindle diameter. It is specifically designed to fit the Loctite/Multicore 250g rolls, but fits lots of other brands as well. There are 2 versions with and without a guide/holder for the loose solder wire. Required hardware - With...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Joshua Marshall.
Archivos (7)
- Solder_Spool_Holder_with_Guide_-_Side_1.stl STL · 525 KB
- Solder_Spool_Holder_with_Guide_-_Side_2.stl STL · 143 KB
- Solder_Spool_Holder_-_Axle.stl STL · 1,1 MB
- Solder_Spool_Holder_-_Side_1.stl STL · 174 KB
- Solder_Spool_Holder_-_Side_2.stl STL · 106 KB
- Solder_Spool_Holder_with_Guide.step STEP · 488 KB
- Solder_Spool_Holder.step STEP · 361 KB
- Categoría
- Herramientas
- Formatos
- STL, STEP
- Descargas
- 6,609
- Publicado
Sobre este modelo
This is a solder spool holder for 200g - 250g spools with 20mm spindle diameter. It is specifically designed to fit the Loctite/Multicore 250g rolls, but fits lots of other brands as well. There are 2 versions with and without a guide/holder for the loose solder wire. Required hardware - With Guide: 3 x Counter sunk M3 x 12-16mm machine or self tapping screws
- Without guide: 2 x Counter sunk M3 x 12-16mm machine or self tapping screws
For consistent finish print the 2 sides with the outside surface on the bed, no supports required.
Descripción original del autor, publicada en Thingiverse.
