Soda can lid with a tight fit and knurling
por Dan Vunck en Thingiverse
I liked the original design to put a lid on a drink can, but, at least on my cans, it was quite a loose fit. I slightly shrunk the design to make it a tight friction fit. It was then quite difficult to remove, so I added some knurling to the outer edge so you could get a better grip to twist and...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Dan Vunck.
Archivos (1)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 443
- Publicado
Sobre este modelo
I liked the original design to put a lid on a drink can, but, at least on my cans, it was quite a loose fit. I slightly shrunk the design to make it a tight friction fit. It was then quite difficult to remove, so I added some knurling to the outer edge so you could get a better grip to twist and remove the cap I printed mine with PETG, .16 layer height, 15% infill, & no supports (The text on the top was added after printing with a laser engraver and a paint pen)
Descripción original del autor, publicada en Thingiverse.
