Snapmaker U1 Gridfinity Hotend Holder Holder
por remmulegguh en Printables
Holder for Snapmaker U1 Gridfinity Hotend Holder
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a remmulegguh.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 29
- Publicado
Sobre este modelo
Needed to improve the hot end changing setup with the original top cover. Found a genious holder for the tool head, then made a secondary holder for the screws, rear cover and the hex key. Now the setup is complete with the hotends that are otherwise stored in the drawer. It holds any gridfinity tray, intended for the Snapmaker U1 Gridfinity Hotend Holder. - https://www.printables.com/model/1563570-snapmaker-u1-gridfinity-hotend-holder-4u-height
- https://www.printables.com/model/1504858-snapmaker-u1-gridfinity-hotend-holder
The other two holders: - https://www.printables.com/model/1833446-snapmaker-u1-toolhead-holder-v2-remix
- https://www.printables.com/model/1908351-snapmaker-u1-toolhead-helper
Magnets optional (holds well even without); file designed for D=2.5mm x h=2.6mm magnets. Prints without supports.
PS: I also made a cover for the gridfinity hotend holders to keep the hotends clean and dry
Descripción original del autor, publicada en Printables.
