Snap-In Cable Clips – 4 Sizes (3.5 / 5 / 7 / 10 mm), Tape or Screw Mount, No Supports
por Gundabadad en Cults3D
Route cables neatly along desks, walls, shelves, behind TVs or inside a 3D printer enclosure. These snap-in cable clips hold the cable firmly but let you pop it in and out by hand.
Cults3D entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalLicencia de uso privado de Cults3D: puedes imprimirlo para ti. No se permite compartir el archivo ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Gundabadad.
Archivos (5)
- cable_clip_10mm.stl STL
- cable_clip_3_5mm.stl STL
- cable_clip_5mm.stl STL
- cable_clip_7mm.stl STL
- cable_clip_set_all_4_sizes.stl STL
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Route cables neatly along desks, walls, shelves, behind TVs or inside a 3D printer enclosure. These snap-in cable clips hold the cable firmly but let you pop it in and out by hand.
Includes 5 STL files:
- 3.5 mm clip – thin USB / earphone / LED strip cables
- 5 mm clip – USB-C, Lightning, HDMI mini, most charging cables
- 7 mm clip – HDMI, monitor, laptop and thicker USB cables
- 10 mm clip – power cords, thick cables or small bundles
- A set plate with one of each size
Features
- C-shaped snap-in ring with a chamfered lead-in – press the cable in, it clicks into place
- Flat 10 mm wide base for double-sided tape (3M VHB or similar)
- Screw hole in the side tab (for 3 mm screws) if you'd rather screw it down
- Small and fast – about 5 minutes and 1 g of filament per clip, so print as many as you need
Sizes: 25–32 mm long, 10 mm wide, 6–11 mm tall.
Descripción original del autor, publicada en Cults3D.
