Smartphone Tripod for Landscape/Portrait mode
por Iggy Groß en Thingiverse
This a remix of trentesous' very good foldable tripod Version 2. I remade the phone mount to rotate, allowing for both landscape and portrait modes. Find the original here: https://www.thingiverse.com/thing:2862445 Printing tips: - Make sure to enable supports but use support blockers for the...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Iggy Groß.
Archivos (10)
- tripod_screw_V2_trentesous.STL STL · 2,4 MB
- Tripod_leg_3_V2_trentesous.STL STL · 311 KB
- Tripod_leg_2_V2_trentesous.STL STL · 1,7 MB
- Tripod_leg_1_V2_trentesous.STL STL · 1,5 MB
- tripod_base_V2_trentesous.STL STL · 2,0 MB
- tripod_screw_base_V2_trentesous.STL STL · 2,7 MB
- tripod_mount.stl STL · 228 KB
- tripod_phone_holder_1.stl STL · 95 KB
- tripod_phone_holder_2.stl STL · 1,5 MB
- tripod_screw_mount.stl STL · 5,7 MB
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 9,345
- Publicado
Sobre este modelo
This a remix of trentesous' very good foldable tripod Version 2. I remade the phone mount to rotate, allowing for both landscape and portrait modes. Find the original here: https://www.thingiverse.com/thing:2862445 Printing tips: - Make sure to enable supports but use support blockers for the threaded bits - The orientation of the parts should be as shown in the screenshot above - I suggest using Gyroid infill with a high density of ~50% for the screws and ~20% for the rest
Descripción original del autor, publicada en Thingiverse.
