Small Battery Dispenser Hoder with Low Battery Box
por Robert 3dPrinter en Thingiverse
I reduced the height to 6 cm. Also, cut the AA slot 1 mm and the AAA slot 2 mm in hoping the dispensing works. I fixed mine with a hairdryer then added the extra cuts in the model. The AA section back corner got some warping on my print. Update 11.01.2023: I edited the thing, made some extra room...
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Robert 3dPrinter.
Archivos (3)
- Categoría
- Organización
- Formatos
- STL
- Descargas
- 9,733
- Publicado
Sobre este modelo
I reduced the height to 6 cm. Also, cut the AA slot 1 mm and the AAA slot 2 mm in hoping the dispensing works. I fixed mine with a hairdryer then added the extra cuts in the model. The AA section back corner got some warping on my print. Update 11.01.2023: I edited the thing, made some extra room for batteries to exit the towers. I also added the empty battery container. I added a second model for the holder, with a hole beneath the empty battery container to give a little help to push it upwards to pull it out. I did not print it in this version. Any feedback is appreciated. Update 01.2025 Make sure you check out the remixes. This is a much better IMHO: design: https://www.thingiverse.com/thing:6901650
Descripción original del autor, publicada en Thingiverse.
