Sleeve Case for Raspberry Pi

Update May 2018 see lienbacher's comment below for a version that will work with a Pi 3 B+, which has addition POE pins. I updated the v2.1 version on here with a larger pin cutout but don't have a Pi 3 B+ to test with Updated March 2018: Added a new version (2.0) with a larger cutout for the microSD card since newer models aren't spring loaded. I also loosened up the tolerances and tweaked the design to make it easier to print, and added a latch to the cap so the Raspberry Pi is less likely to fall out. Simple sleeve to protect a Raspberry Pi* from falling screws. The main part of the case slides over the Raspberry Pi, and a cap fits around the connectors. The parts are only held in place by friction so it probably isn't a good option for transport or if you frequently plug / unplug devices (mine just sits under my printer running Octoprint). Only the ports along the sides are exposed. The cap part may need a small amount scaling on the z axis since the height can vary significantly with layer height and first layer thickness. Filament: -- Colorfabb Red PLA/PHA* -- ESun Yellow PLA* -- Filamentum Vertigo Grey PLA* -- Sainsmart Clear PETG* Several other of my PI case designs can be found in this collection. *affiliate links