Simple Wall Grommet 15mm
por Olitoady en MakerWorld
Hi! :). This is a very simple design, and only my second file shared here as I'm still a beginner in 3D modeling (trying FreeCAD instead of Blender, which I'm bad at too!).
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Olitoady.
Archivos (1)
- wallpassthrough.FCStd FCSTD · 79 KB
- Categoría
- Herramientas
- Formatos
- FCSTD
- Descargas
- 0
- Publicado
Sobre este modelo
Hi! :) This is a very simple design, and only my second file shared here as I'm still a beginner in 3D modeling (trying FreeCAD instead of Blender, which I'm bad at too!).
I created this cable grommet to get a much nicer wall finish when routing my internet cable behind my desk. It is designed for a wall hole of about 16mm (with the safety cylinder) or around 15mm without but I now realised it could be fine without it.
I might try to do better version where the safety cylinder has a front plate so the cut out is less visible. but right now its under my desk pretty much hidden.
Hope you find it useful! Feedback is always appreciated.
P.S : I printed this in PLA Matte Ivory White because that's what was in my AMS (and my wall is white, lol).
Thank you! :)
Descripción original del autor, publicada en MakerWorld.
