Simple PET Bottle Cutter
por mirabatek en Printables
This is simple bottle cutter for cuting strips from PET bottles. The strips are then recycled to filament
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a mirabatek.
Archivos (15)
- PET_Bottle_Cutter_Body.stl STL · 421 KB
- PET_Bottle_Cutter_Knob_M8.stl STL · 1,5 MB
- PET_Bottle_Cutter_Knob_M8_Small.stl STL · 1,6 MB
- PET_Bottle_Cutter_Template.stl STL · 539 KB
- PET_Bottle_Cutter_Circle_8mm.stl STL · 752 KB
- PET_Bottle_Cutter_Circle_2mm.stl STL · 739 KB
- PET_Bottle_Cutter_Circle_6mm.stl STL · 735 KB
- PET_Bottle_Cutter_Circle_1mm.stl STL · 739 KB
- PET_Bottle_Cutter_Circle_0.5mm.stl STL · 554 KB
- Spacer_10mm.stl STL · 1,2 MB
- Spacer_9mm.stl STL · 1,2 MB
- Spacer_8.5mm.stl STL · 1,6 MB
- Spacer_8mm.stl STL · 1,3 MB
- Spacer_7mm.stl STL · 827 KB
- Spacer_6mm.stl STL · 1,2 MB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 11,317
- Publicado
Sobre este modelo
You can use the PET Bottle Cutter to cut sprips from the PET bottles with selected width. The width is defined by spacers which are put under the blade. The PET strip can be then used in machine which converts it to filament for 3D printers. I'm using this bottle cutter for some time and it works very well. You will gain the skill after a few bottles. The metal sheet from the bottle can protects the plastic body because the edges of the bottle and strip are quite sharp and can scratch the plastic. Bill of material: - M8 screw rod with length about 40-45cm - 2x M8x40 screw - 4x M8 nut - 4x M3.5x20 woodscrew - 9mm cutting blade - Bottle can
Assembly: - Print all the parts (M8 nuts are inserted inside the knobs during print) - Cut the bottle can sheet according to the template - Wrap the sheet abound the body - Insert the nut and screws inside the body - Insert the needed spacers - Put the cutting plade on the spacers and prot it up agains the screws - Add the rest of the spacers and tight them with the knob - Add the screw rod to support the bottle
You can follow the photos. Here you can see how I cut a bottle using this cuter:
Check also my PET Strip Spooler and Spool Holder and PET Bottle Cutter with Bearings.
Update 12.1.2023 - Added spacers with emposed height Update 18.4.2023 - Added smaller version of the knob (PET_Bottle_Cutter_Knob_M8_Small.stl)
Descripción original del autor, publicada en Printables.
