Simple cable covers for Multiboard

Simple cable channels that clamp inside of the big thread holes of Multiboard.

This is brand new and I just got testing them myself but I use ASA. I am looking for feedback on flexibility regarding PLA/PETG, etc. because this design is based on not having to use any screws or a top/bottom part but just on flexing the cover to fit the holes and stay clamped in there.

One gotcha with this design as that if you cross any snap or medium/small hole in the way, it does not support anything else than a big thread hole. So you will need to remove clips where there can't be a clip. You can snap it off physically with pliers and cut the rest with a utility knife or sand it down or use a deburring tool.

There is only one stl file because it is required but if you download the zip file and extract it, you will see a folder structure organized by part type and then various sizes for width/height/lenght. All units are multiples of 25mm. So a 0.5Height part is 12.5mm height from the surface of the board, etc.

NOTE: I will add Y and Height-Chaning parts very soon, I just need to export them and update this listing.