Silica Gel Box Cap – Snug Fit with Pry Ledge
por The_Jackalope en Printables
Drop-in replacement cap for the silica gel box that stays put when the box is on its side, but pops off with your thumb.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a The_Jackalope.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- 3MF
- Descargas
- 0
- Publicado
Sobre este modelo
A remix of the silica gel box cap from Korakot E.’s Ikea 365+ 10.6L Spool Holder / Filament Dry Box. The original cap didn’t hold well. This one presses in snugly, so beads won’t spill when the box is tipped or on its side, and the overhanging ledge on one edge gives you leverage to pop it off when it’s time to swap or dry the silica gel. Works with the original silica gel box base, so you don’t need to reprint it. Print settings - Material: PETG (tested). PETG’s flex helps the nubs grip. PLA may be noticeably tighter.
- Orientation: top face on the bed, lip and nubs pointing up
- Supports: none
Fit tuning: Scale up or down by 0.5% to get proper fit as needed.
Descripción original del autor, publicada en Printables.
